Coordinate all disciplines using Virtual Reality in the Autodesk Drive

By Design Scientist Earl S Bell

The site shown is a green HRMA ( Hyper Rapid Manufacturing Arm ) technology incubator site where offices, retail, residential, electric vehicle charging, recreation, and light manufacturing are all located in a tight mixed use environment.  The close proximity of retail to manufacturing helps create an instant feedback loop for customer appreciate quality control and a chance for the local community to be energized by seeing the entire cycle of technology creation- adoption.

Scan or click the QR code below to enter the Green Incubator Site.

 

This Design is in progress. You are welcome to take a look at the design process, feel free to cut a section of the entire site or take measurements of trusses, columns and retail floor to ceiling heights. “Autodesk Drive” is the technology that allows the site to be viewed.

 

Leave a Reply

Your email address will not be published. Required fields are marked *